Four Skills on Reducing the Spare Parts of Hammer Crusher
Hammer crusher can crush the material with 600-1800mm granularities to 25mm or below. It is suitable for medium and fined crushing process of cement, chemical, electricity and metallurgy industries to crush medium hardness material like limestone, slag, coke and coal.
How to Reduce the Spare Parts Replacement of Hammer Crusher?
Hammer crusher is one of the high efficiency crispy material processing equipment with low operation cost. But during production activities, it also generates lots of problems. For instance, hard metal falls into the chamber, which may increase the consumption of the grates. Luoyang Dahua assists with the customers and does on site research listing four production factors that are necessary to production.
Grates are the common spare parts of the hammer crusher. The reason why grates are easily worn out is it strikes materials, especially, hard material. When unbreakable materials fall into the hammer crusher chamber, it may severely block the grates. The material in the crusher chamber may increase the work-load of grates, which may easily cause the broken of grates.
1. Properly reduce the height of rib plate, take higher 50mm than the rib plate as the standard. Moreover, we can weld reinforce plate on the side of the rib plate to strengthen its strength and make sure the reinforced rib plate can withstand wearing and impacts.
2. When the installation of the hammer crusher is over, we need to clean up the crushing chamber of the hammer crusher before put it into production. Make sure the obstacles and small parts are out of the crusher.
3. Reduce the chances of iron block and unbreakable objects falls into the crushing chamber. We usually let the material to be crushed goes through the magnetic separator first to remove those iron block or unbreakable material.
4. The operator should make regular check on of the machine during machine operation. When hearing strange noise, please stop the machine and have a check. Remove obstacles out of the crusher to avoid the rib plate damaged caused by them.
Previous Article：Steps for Removing the Jaw Plate of the Jaw Crusher
Next Article: Inspection Matters of Limestone Crusher